Nonlinear optics
From Academic Kids

Nonlinear optics is the branch of optics that describes the behaviour of light in nonlinear media, that is, media in which the polarization P responds nonlinearly to the electric field E of the light. This nonlinearity is typically only observed at very high light intensities such as provided by pulsed lasers.
Nonlinear optics gives rise to a host of optical phenomena:
Contents 
Frequency mixing processes
 Second harmonic generation (SHG), or frequency doubling, generation of light with a doubled frequency (half the wavelength);
 Sumfrequency generation (SFG), generation of light with a frequency that is the sum of two other frequencies (SHG is a special case of this);
 Third harmonic generation (THG), generation of light with a tripled frequency (onethird the wavelength) (usually done in two steps: SHG followed by SFG of original and frequencydoubled waves);
 Differencefrequency generation (DFG), generation of light with a frequency that is the difference between two other frequencies;
 Parametric amplification, amplification of a signal input in the presence of a higherfrequency pump wave, at the same time generating an idler wave (can be considered as DFG);
 Parametric oscillation, generation of a signal and idler wave using a parametric amplifier in a resonator (with no signal input);
 Parametric generation, like parametric oscillation but without a resonator, using a very high gain instead;
 Spontaneous parametric downconversion, the amplification of the vacuum fluctuations in the low gain regime;
 Optical rectification, generation of quasistatic electric fields.
Other nonlinear processes
 Optical Kerr effect, intensity dependent refractive index;
 Self focusing;
 Kerrlens modelocking (KLM).
 Selfphase modulation (SPM);
 Optical solitons.
 Crossphase modulation (XPM);
 Fourwave mixing (FWM), can also arise from other nonlinearities.
 Self focusing;
 Raman scattering, interaction of photons with optical phonons;
 Raman amplification,
 Optical phase conjugation.
 Brillouin scattering, interaction of photons with acoustic phonons;
 Optical phase conjugation.
 Twophoton absorption, simultaneous absorption of two photons, transferring the energy to a single electron;
 Multiple photoionisation, nearsimultaneous removal of many bound electrons by one photon.
Related processes
In these processes, the medium has a linear response to the light, but the properties of the medium are affected by other causes:
 Pockels effect, the refractive index is affected by a static electric field; used in electrooptic modulators;
 Acoustooptics, the refractive index is affected by acoustic waves (ultrasound); used in acoustooptic modulators.
Frequencymixing processes
One of the most commonlyused frequencymixing processes is frequency doubling or secondharmonic generation. With this technique, the 1064nm output from Nd:YAG lasers or the 800nm output from Ti:sapphire lasers can be converted to visible light, with wavelengths of 532 nm (green) or 400 nm (violet), respectively.
Practically, frequencydoubling is carried out by placing a special crystal in a laser beam under a wellchosen angle. Commonlyused crystals are BBO (βbarium borate), KDP (potassium dihydrophosphate), and lithium niobate. These crystals have the necessary properties of being strongly birefringent (necessary to obtain phase matching, see below), having a specific crystal symmetry and of course being transparent for and resistant against the highintensity laser light.
Theory
A number of nonlinear optical phenomena can be described as frequencymixing processes. In general, the dielectric polarization <math>P(t)<math> at time <math>t<math> in a medium can be written as a power series in the electrical field:
 <math>P(t) \propto \chi^{(1)} E(t) + \chi^{(2)} E^2(t) + \chi^{(3)} E^3(t) + \cdots<math>.
Here, the coefficients <math>\chi^{(n)}<math> are the <math>n<math>th order susceptibilities of the medium. For any threewave mixing process, the secondorder term is crucial; it is only nonzero in media that have a broken inversion symmetry. If we write
 <math>E(t) = E_1 e^{i \omega_1 t} + E_2 e^{i \omega_2 t} + {\rm c.c.}<math>,
where c.c. denotes the complex conjugate, the secondorder term in will read
 <math> P^{(2)}(t) \propto \sum\chi^{(2)} n_0 E_1^{n_1} E_2^{n_2} e^{i (m_1\omega_1 + m_2\omega_2) t } + {\rm c.c.}<math>,
where the summation is over
 <math>(n_0,n_1,n_2,m_1,m_2) = (1,2,0,2,0),\; (1,0,2,0,2),\; (2,2,0,0,0),\; (2,0,2,0,0),\; (2,1,1,1,1),\; (2,1,1,1,1)<math>.
The six combinations <math>(n_x,m_x)<math> correspond, respectively, to the second harmonic of <math>E_1<math>, the second harmonic of <math>E_2<math>, the optically rectified signals of <math>E_1<math> and <math>E_2<math>, the difference frequency, and the sum frequency. A medium that is thus pumped by the fields <math>E_1<math> and <math>E_2<math> will radiate a field <math>E_3<math> with an angular frequency <math>\omega_3 = m_1\omega_1 + m_2\omega_2<math>.
Note: in this description, <math>\chi^{(2)}<math> is a scalar. In reality, <math>\chi^{(2)}<math> is a tensor whose components depend on the combination of frequencies.
Parametric generation and amplification is a variation of difference frequency generation, where the lowerfrequency one of the two generating fields is much weaker (parametric amplification) or completely absent (parametric generation). In the latter case, the fundamental quantummechanical uncertainty in the electric field initiates the process.
Phase matching
The above ignores the position dependence of the electrical fields. In a typical situation, the electrical fields are traveling waves described by
 <math>E_j(\mathbf{x},t) = e^{i(\omega_j t  \mathbf{k}_j \cdot \mathbf{x})}<math>,
at position <math>\mathbf{x}<math>, with the wave vector <math>\mathbf{k}_j = n(\omega_j)\omega_j/c<math>, where <math>c<math> is the velocity of light and <math>n(\omega_j)<math> the index of refraction of the medium at angular frequency <math>\omega_j<math>. Thus, the secondorder polarization angular frequency <math>\omega_3<math> is
 <math>P^{(2)} (\mathbf{x}, t) \propto E_1^{n_1} E_2^{n_2} e^{i (\omega_3 t  (m_1 \mathbf{k}_1 + m_2 \mathbf{k}_2)\cdot\mathbf{x})}<math>.
At each position <math>\mathbf{x}<math>, the oscillating secondorder polarization radiates at angular frequency <math>\omega_3<math> and a corresponding wave vector <math>\mathbf{k}_3 = n(\omega_3)\omega_3/c<math>. Constructive interference, and therefore a high intensity <math>\omega_3<math> field, will occur only if
 <math>\mathbf{k}_3 = m_1 \mathbf{k}_1 + m_2 \mathbf{k}_2<math>.
The above equation is known as the phase matching condition. Typically, threewave mixing is done in a birefringent crystalline material (I.e., the refractive index depends on the polarization and direction of the light that passes through.), where the polarizations of the fields and the orientation of the crystal are chosen such that the phasematching condition is fulfilled. This phase matching technique is called angle tuning.
One undesirable effect of angle tuning is that the optical frequencies involved are not collinear with each other. This is due to the fact the extraordinary wave propagating through a birefringent crystal posses a Poynting vector is not parallel with the propagation vector. This would lead to beam walkoff which limits the nonlinear optical conversion efficiency. Two other methods of phase matching avoids beam walkoff by forcing all frequencies to propagate at 90 degree angle with respect to the optical axis of the crystal. These methods are call temperature tuning and quasiphase matching.
Temperature tuning is where the pump (laser) frequency polarization is orthogonal to the signal and idler frequency polarization. The birefringence in some crystals, in particular Lithium Niobate is highly temperature dependent. The crystal is controlled at a certain temperature to achieve phase matching condition.
The other method quasiphase matching. In this method the frequencies involved are not constantly locked in phase with each other, instead the crystal axis is flipped at a regular interval λ, typically 15 micrometres in length. Hence, these crystals are called periodicallypoled. This results in the polarization response of the crystal to be shifted back in phase with the pump beam by reversing the nonlinear susceptibility. This allows net positive energy flow from the pump into the signal and idler frequencies. In this case, the crystal itself provides the additional wavevector k=2π/λ(and hence momentum) to satisfy the phase matching condition.
Higherorder frequency mixing
The above holds for <math>\chi^{(2)}<math> processes. It can be extended for processes where <math>\chi^{(3)}<math> is nonzero, something that is generally true in any medium without any symmetry restrictions. Thirdharmonic generation is a <math>\chi^{(3)}<math> process, although in laser applications, it is usually implemented as a twostage process: first the fundamental laser frequency is doubled and then the doubled and the fundamental frequencies are added in a sumfrequency process. The Kerr effect can be described as a <math>\chi^{(3)}<math> as well.
Optical phase conjugation
PhaseConjugationPrinciple.en.png
It is possible, using nonlinear optical processes, to exactly reverse the propagation direction and phase variation of a beam of light. The reversed beam is called a conjugate beam, and thus the technique is known as optical phase conjugation (also called time reversal, wavefront reversal and retroreflection).
The most common way of producing optical phase conjugation is to use a fourwave mixing technique, though it is also possible to use processes such as stimulated Brillouin scattering. A device producing the phase conjugation effect is known as a phase conjugate mirror (PCM).
For the fourwave mixing technique, we can describe four beams (j = 1,2,3,4) with electric fields:
 <math>\Xi_j(\mathbf{x},t) = \frac{1}{2} E_j(\mathbf{x}) e^{i (\omega_j t  \mathbf{k}\cdot\mathbf{x})} + \mbox{c.c.} <math>
where E_{j} are the electric field amplitudes. Ξ_{1} and Ξ_{2} are known as the two pump waves, with Ξ_{3} being the signal wave, and Ξ_{4} being the generated conjugate wave.
If the pump waves and the signal wave are superimposed in a medium with a nonzero χ^{(3)}, this produces a nonlinear polarization field:
 <math>P_{\mbox{NL}} = \epsilon_0 \chi^{(3)} (\Xi_1 + \Xi_2 + \Xi_3)^3<math>
resulting in generation of waves with frequencies given by ω = ±ω_{1} ±ω_{2} ±ω_{3} in addition to third harmonic generation waves with ω = 3ω_{1}, 3ω_{2}, 3ω_{3}.
As above, the phasematching condition determines which of these waves is the dominant. By choosing conditions such that ω = ω_{1} + ω_{2}  ω_{3} and k = k_{1} + k_{2}  k_{3}, this gives a polarization field:
 <math>P_\omega = \frac{1}{2} \chi^{(3)} \epsilon_0 E_1 E_2 E_3^* e^{i(\omega t  \mathbf{k} \cdot \mathbf{x} ) } + \mbox{c.c.}<math>.
This is the generating field for the phase conjugate beam, Ξ_{4}. Its direction is given by k_{4} = k_{1} + k_{2}  k_{3}, and so if the two pump beams are counterpropagating (k_{1} = k_{2}), then the conjugate and signal beams propagate in opposite directions (k_{4} = k_{3}). This results in the retroreflecting property of the effect.
Further, it can be shown for a medium with refractive index n and a beam interaction length l, the electric field amplitude of the conjugate beam is approximated by
 <math>E_4 = \frac{i \omega l}{2 n c} \chi^{(3)} E_1 E_2 E_3^* <math>
(where c is the speed of light). If the pump beams E_{1} and E_{2} are plane (counterpropagating) waves, then:
 <math>E_4(\mathbf{x}) \propto E_3^*(\mathbf{x})<math>;
that is, the generated beam amplitude is the complex conjugate of the signal beam amplitude. Since the imaginary part of the amplitude contains the phase of the beam, this results in the reversal of phase property of the effect.
Note that the constant of proportionality between the signal and conjugate beams can be greater than 1. This is effectively a mirror with a reflection coefficient greater than 100%, producing an amplified reflection. The power for this comes from the two pump beams, which are depleted by the process.
The frequency of the conjugate wave can be different from that of the signal wave. If the pump waves are of frequency ω_{1} = ω_{2} = ω, and the signal wave higher in frequency such that ω_{3} = ω + Δω, then the conjugate wave is of frequency ω_{4} = ω  Δω. This is known as frequency flipping.
External link
 Encyclopedia of laser physics and technology (http://www.rpphotonics.com/encyclopedia.html), with content on nonlinear optics, by Rüdiger Paschottade:Nichtlineare_Optik